Tandem Dryer Setup

This version of connecting the dryers together does not require additional parts.

The only tool required is a screwdriver.

Depending on the arm length of the person moving the hose, removing the water tanks is likely unnecessary.

• Two hoses are located under the tub. The HanV Dryer hose going to the table will be used.
• Unscrew the red screw and detach the hose from the coupling, circled in red.
• Pull the top part of the hose out of the “C” clip, circled in green.
• Go to the back of the van on the plumbing side of the equipment area. Follow the HanV dryer hose and pull the opposite end all the way through from the back of the tub. Now, we will feed the hose end with the white coupling over the water tanks and behind the dividing wall to the electrical side of the equipment area.
• Unscrew the red screw on the back of the Fluff dryer that holds the small filter in place and remove it, circled in blue.
• Attach the white coupling to the back of the Fluff dryer and reattach the red screw.

Your dryers are now in tandem!
All air will now feed through the Fluff Dryer hose at the tub.
Keep the remaining hose from the HanV Dryer in a safe place for later use.
If you decide you do not like the dryers in tandem, it is reversible.